The SW0231MG is a budget plan friendly waterproof digital servo with fantastic torque for numerous applications. This brushed servo features a speed of .17 and 208.0 oz-in of torque 6.0V. It combines leading edge technology with very high 12-bit (4096) resolution and metal gears for your greater precision when dodging puddles. This is a fantastic upgrade if your wanting to drive your RC car in any condition...rain, sleet, or snow.
Features:
Combines leading edge technology with very high 12 bit (4096) resolution and metal gears.
Waterproof.
Brushed motor
Incredibly strong metal gears guarantee long-life and durability.
Our servos are completely green ? from materials to production, these servos are environmentally friendly.
Ideal for RC vehicles, trucks, buggies, and boats.
This product is often purchased with the above discussed product.
This is the Axial 25T Aluminum Servo Horn for Futaba, Axial and Savox Servos.
FEATURES: Difficult anodized aluminum building Compression mount, two screws install on either side of arm and tighten center hole around servo spline
INCLUDES: Axial 25T Aluminum Servo Horn Two 2x8mm socket head screws
SPECS: Length: 0.98" (25mm) from center of servo mounting hole to end of arm Hole Diameter: 3mm Pitch:3x30
This product is often purchased with the above discussed product.
This is a optional Racers Edge Aluminum single arm servo horn, meant for use with Futaba servos. This sturdy aluminum servo horn is similar in design to the Racers Edge Pro Adjustable servo horns, but features a third linkage mounting point and does not use lock down screws.
This product compliments the above talked about product.
This is the 3-Channel Futaba 3PRKA 2.4GHz FHSS Radio System with the R203GF Receiver.
FEATURES: Suitable upgrade for radios found in RTR cars Throttle and steering trim and reverse Steering dual rate dial Throttle end point modification Channel three switch Throttle fail safe One year restricted guarantee through Hobby Services beginning at date of purchase
INCLUDES: Futaba 3PRKA 2.4GHz FHSS Transmitter, R203GF Receiver, Direction Manual and On/Off Switch
REQUIRES: Servos of modeler's choice Four AA batteries for transmitter
SPECS: Transmitter: Transferring Frequency: 2.4GHz band Power Requirement: Four AA cells Present Drain: 100mA or less
Receiver; Dimensions: 1.54 x 1.02 x 0.39" (39 x 26 x 10mm) Weight: 0.28oz (8g) Operating Voltage: 4.8 - 7.4V (shared with servo) Battery Fail Safe Voltage: 3.8V* Present Drain: 30mA at no signal *Battery fail safe voltage is set for 4-cell NiCd/NiMH battery Battery F/S does not work correctly when other type of battery is used
COMMENTS: 2.4GHz FHSS is not compatible with FASST systems. Normal mode frame rate is (FHSS/S-FHSS) 13.63ms and accepts any type of servos or peripherals. High-Speed mode (in 4PL tx only), with an output of 6.8ms accepts digital servos including the BLS series and most peripheral equipment such as brushless ESCs